One interface in front of a supply network
We do not run a factory. The six product lines on this site are made on supplier lines we have inspected, and every part reaches you through one interface: one specification, one certificate pack, one address that answers.
· A braiding bay our orders run through. It is a supplier's line, not ours.
A supply network, not a factory
A liquid cooling loop is bought as one system and maintained as many parts. Housings, hose, seals, sensing rope and instruments come from different workshops, and the buyer carries the job of making them agree with each other. That job is what this sheet takes over.
Six lines are held to one specification, one cleanliness target and one packing standard. What changes for you is the number of interfaces: drawings, certificates and shipping documents arrive from one place, against one document number, instead of six.
· The parts live under the tiles. Anything supplied has to survive there.
· One interface, cut to one drawing, whether the part came from bay one or bay six.
Every line, and the figure that decides it
| Line | Supplied | Decisive figure | Interface |
|---|---|---|---|
| Leak detectionLine 01 | Locating sensing rope, point sensors, controllers, end terminations | 500 m per channel | Modbus RTU · dry contact |
| Coolant filtrationLine 02 | Housings, cartridges, and the in-line water quality transmitters | 1 µm absolute | ISO 4406 17/15/12 |
| Hose and pipingLine 03 | EPDM hose assemblies, metal fittings, quick disconnects | 1.38 MPa ≈ 200 psi | UQD · DASH −4 to −10 |
| Thermal materialsLine 04 | Grease, gap filler pads, phase change material, graphite sheet | 1.0–15.0 W/m·K | Bond line · pump-out |
| Telemetry instrumentsLine 05 | Flow, differential pressure, level, conductivity and pH instruments | 4–20 mA | Modbus RTU · dry contact |
| Fill and flushLine 06 | Service carts, filtration units, sampling points, target cleanliness | ISO 4406 17/15/12 | Two-stage filtration |
Figures are the ones the line is quoted on. Line 02 is quoted at the 1 µm grade; the other seven cartridge grades are quoted per size. Line 06 is quoted against the cleanliness target, not against a volume.
One mount per line, at the size the line is quoted at. Links to the full schedule of each line are in the index at the top of this sheet.
The interface, in three parts
· A cut fitting from the quotation pack. Length and bore are the only two call-outs.
· The same interface turned through ninety degrees, with the hex flats dimensioned.
· A moulded profile gasket. The seal is drawn, not matched by eye at the bench.
Inspection, and the record that follows the part
A part is only as good as the batch it came out of. Every line runs the same four checkpoints, and every one of them writes a line into the record that ships with the goods.
- Incoming material: grade, hardness and dimensional check against the drawing
- In process: torque, seal face and thread gauges on the parts that make up
- Before dispatch: pressure proof, plus a burst sample per hose batch
- Records: certificate, test report and packing list raised against one document number
· Incoming material is measured against the drawing, not against the last delivery.
· The piece the record is raised against: one assembly, one batch, at the station it was built on.
· An incoming O-ring. Hardness and cross section are measured, not assumed from the part number.
· One batch, one size, six pieces. The sample that goes into the record comes off the top of this pile.
Four documents are held for this sheet. Tick the ones you need.
Tick a document, name the line and the quantity, and the file comes back attached.
One business day, with the file attached.
Nothing else on this sheet is promised. Price, stock and lead time are not promised here.